Tracker 4WD L4-1.6L VIN 6 (1998)
Case: Service and Repair
Rear Case Removal
REMOVAL PROCEDURE
^
Tools Required
-
J29369-01 Output Shaft Bearing Remover
-
J23907 Slide Hammer
-
J35664 Bearing Installer
1. Remove the gearshift lever case from the transmission. Refer to Gearshift Lever Case Removal.
2. Remove the transfer case from the vehicle.
3. Remove the following items from the transmission:
^
The twelve bolts.
^
The rear case.
4. Remove the rear case oil seal (2) from the rear case (1) using the J 29369-01 with the J 23907
5. Remove the rear case countershaft plug (2) from the rear case (1) using the J 35664 and a hammer.
6. Clean the rear case and the transmission mating surfaces.
7. Clean the gearshift lever case and the rear case mating surfaces.
8. Inspect the rear case for cracks or porosity. If cracks or porosity exist, replace rear case.
