Pacifica V6-3.8L VIN L (2005)
Fig. 12
11. Remove attaching screw from D-pillar reinforcement molding and remove, if necessary (Fig. 12).
INSTALLATION
1. Install D-pillar reinforcement molding attaching screw to body side, if necessary (Fig. 12).
2. Place D-pillar trim into position (Fig. 11).
3. Pass seat belt through slot in D-pillar trim panel.
4. Press on D-pillar trim to engage locking tabs.
5. Install two screw attaching upper D-pillar.
6. Connect power liftgate link from ball head bracket, if equipped.
7. Install upper trim panel on liftgate, if equipped with power liftgate (Fig. 10).
8. Install bolt attaching second row seat belt lower anchor to quarter trim panel.
9. Install liftgate sill scuff plate. Refer to Trim Panel.
10. Install rear header trim cover.
Quarter Panel Trim
QUARTER TRIM PANEL
REMOVAL
1. Open rear door.
2. Open liftgate.
3. Remove rear door sill scuff plate. Refer to Trim Panel.
4. Remove liftgate sill scuff plate. Refer to Trim Panel.
5. Fold the first row seat back down and roll seat forward.
6. Fold second row seat back down.
7. Remove rear floor storage bin.
8. Remove second row seat from vehicle to access quarter trim panel.
9. Remove C-pillar lower seat belt anchor and D-pillar lower seat belt anchor.
10. Using a trim stick C-4755 or equivalent, disengage the locking tabs and remove quarter trim panel bolster cover (speaker grille).