Pacifica V6-3.8L VIN L (2005)
18) Install lower cowl trim.
19) Install left front and left rear door weather strips.
20) Install left front and left rear door opening sill scuff plates.
21) Raise and support vehicle.
22) Install cable guide attaching front cable to left body rail (Fig. 70). Install screw and tighten to 17 Nm (150 inch lbs.) torque.
23) Slide equalizer onto front cable housing as shown (Fig. 73).
24) Route front cable above left rear brake tube and rear driveline module (if equipped with AWD) to right rear parking brake cable.
25) While holding cable connector on end of front cable secure with a pair of pliers at the front cable button, Place right rear cable button into cable
connector (Fig. 70). Release cables allowing button to seat. It may take some hand pressure to completely seat button.
26) Place left rear parking brake cable button into equalizer (Fig. 70). Release cables allowing button to seat. It may take some hand pressure to
completely seat button.
27) Lower vehicle.
28) Unlock automatic adjuster in parking brake lever.
29) Connect battery negative cable to battery post.
30) Adjust parking brake shoes.