Pacifica V6-3.8L VIN L (2005)
following two steps.
3) Slide left rear cable button inboard and remove from equalizer (Fig. 70).
4) While holding cable connector on end of front cable secure with a pair of pliers at the front cable button, slide right rear cable button inboard and
remove from cable connector (Fig. 70).
5) Access and remove rear hub and bearing.
6) Remove parking brake cable bolt at knuckle (Fig. 80).
7) Remove parking brake shoes from support.
8) Remove shoe actuator from end of cable and support (Fig. 81).
9) Pull cable out of support plate and knuckle.
10) Place a 13 mm 12-point box wrench over cable retainer on end of cable housing at crossmember and collapse retainer fingers (Fig. 82).
11) Remove cable.
INSTALLATION
1) Slide leading end of parking brake cable into hole in flange of crossmember. Slide cable retainer on end of cable housing into hole until retainer
fingers click into place.
2) Slide other end of cable through knuckle and shoe support.
3) Install shoe actuator on end of parking brake cable between parking brake shoes (Fig. 81). Make sure actuator is positioned with word "UP" facing
outward (Fig. 83).
4) Install parking brake shoes on support.
5) Install bolt securing parking brake cable to knuckle (Fig. 80). Tighten bolt to 28 Nm (21 ft. lbs.) torque.
6) Install hub and bearing with wheel speed sensor as well as all components necessary to access it.
7) While holding cable connector on end of front cable secure with a pair of pliers at the front cable button, Place right rear cable button into cable
connector (Fig. 70). Release cables allowing button to seat. It may take some hand pressure to completely seat button.
8) Place left rear parking brake cable button into equalizer (Fig. 70). Release cables allowing button to seat. It may take some hand pressure to
completely seat button.
9) Lower vehicle.
10) Unlock automatic adjuster in parking brake lever.
11) Adjust parking brake shoes as necessary.