Pacifica V6-3.8L VIN L (2005)
9) Place a 13 mm 12-point box wrench over cable retainer on end of cable housing at crossmember and collapse retainer fingers (Fig. 82).
10) Remove cable.
INSTALLATION
1) Slide leading end of parking brake cable into hole in flange of crossmember. Slide cable retainer on end of cable housing into hole until retainer
fingers click into place.
2) Slide other end of cable through knuckle and shoe support.
3) Install shoe actuator on end of parking brake cable between parking brake shoes (Fig. 81). Make sure actuator is positioned with word "UP" facing
outward (Fig. 83).
4) Install parking brake shoes on support.
5) Install bolt securing parking brake cable to knuckle (Fig. 80). Tighten bolt to 28 Nm (21 ft. lbs.) torque.
6) Install hub and bearing with wheel speed sensor as well as all components necessary to access it.
7) Place left rear parking brake cable button into equalizer (Fig. 70). Release cables allowing button to seat. It may take some hand pressure to
completely seat button.
8) Lower vehicle.
9) Unlock automatic adjuster in parking brake lever.
10) Adjust parking brake shoes as necessary.
PARKING BRAKE CABLE RIGHT REAR
REMOVAL
1) Lock out automatic adjuster in parking brake lever.
2) Raise and support vehicle.
NOTE: It may be necessary to back off parking brake shoe adjustment to allow sufficient slack to disengage cable buttons from connectors in