Pacifica V6-3.8L VIN L (2005)
Valve Cover: Service and Repair
Left
CYLINDER HEAD COVER LEFT
REMOVAL
1) Disconnect spark plug wires from spark plugs.
2) Disconnect crankcase vent hose from cylinder head cover.
3) Remove cylinder head cover bolts.
4) Remove cylinder head cover and gasket.
INSTALLATION
1) Clean cylinder head and cylinder head cover mating surfaces. Inspect cylinder head cover surface for flatness. Replace gasket as necessary.
2) Assemble gasket to cylinder cover by inserting the fasteners through each bolt hole on cover and gasket (Fig. 35).
3) Install the cylinder head cover and bolts.
4) Tighten cylinder head cover bolts to 12 Nm (105 inch lbs.) (Fig. 37).
5) Connect crankcase vent hose.
6) Connect spark plug wires to spark plugs.