Pacifica V6-3.8L VIN L (2005)
![background image](/chrysler/pacifica/v6-3.8l_vin_l/Page-588001.png)
Valve Cover: Service and Repair
Right
CYLINDER HEAD COVER -RIGHT
REMOVAL
1) Disconnect negative cable from battery.
2) Disconnect spark plug wires from plugs.
3) Disconnect PCV hose from cylinder head cover (Fig. 34).
4) Remove cylinder head cover bolts.
5) Remove cylinder head cover and gasket (Fig. 35).
INSTALLATION
1) Clean cylinder head and cylinder head cover mating surfaces. Inspect cylinder head cover surface for flatness. Replace gasket as necessary.
2) Inspect seal on the cover bolt for wear or damage (Fig. 35). Replace bolt assembly as necessary.
3) Inspect the PCV hose for damage. replace as necessary.
NOTE: The cylinder head cover bolts contain a torque limiter sleeve and a seal (Fig. 35). The seal and torque sleeve is replaced with the bolt.
4) Assemble gasket to cylinder cover by inserting the bolt assemblies through each bolt hole on the cover and gasket (Fig. 35).