Pacifica V6-3.8L VIN L (2005)
8. Place new knuckle sleeve onto Installer Bolt, Special Tool 9050-4, and slide it up to Bolt's head. (Fig. 14)
9. Install NEW sleeve in knuckle as follows:
a. Slide Installer Bolt 905OA-4 (with sleeve) through knuckle and spring link ball joint starting from knuckle forward end (Fig. 15).
b. Install thrust bearing and nut on end of Bolt (Fig. 15). When installing thrust bearing on Installer Bolt, be sure to place hardened side toward
nut.
c. While holding Bolt head stationary, rotate Nut (using hand tools) installing sleeve in knuckle. Install sleeve until Nut can no longer be turned.
Do not overtighten Nut.
d. Remove tool.
10. Install spring link-to-knuckle bolt and nut as shown (Fig. 9). While holding bolt head stationary, tighten nut to 129 Nm (95 ft. lbs.) torque.
11. Remove under-hoist utility jack or jack stand from under spring link.
12. Install brake caliper adapter. (Fig. 6). Install and tighten mounting bolts to 115 Nm (85 ft. lbs.) torque.
13. Install shoe support with parking brake shoes over hub mounting bolts on knuckle.