Pacifica V6-3.8L VIN L (2005)
16. Remove bolt fastening toe link to knuckle (Fig. 13).
17. Remove nut and bolt fastening stabilizer link to knuckle.
18. Remove nut and bolt fastening tension link to knuckle (Fig. 17).
19. Remove nut and bolt fastening camber link to knuckle (Fig. 17).
20. Remove knuckle.
21. Remove hub mounting bolts from knuckle.
INSTALLATION
1. Install four hub mounting bolts through knuckle from inboard side allowing ends to protrude from opposite side.
2. Slide parking brake cable though mounting hole in rear of knuckle, then position knuckle over outer ends of links.
3. Install bolt and nut fastening camber link to knuckle as shown (Fig. 17). Do not tighten bolt at this time.
4. Install bolt and nut fastening tension link to knuckle as shown (Fig. 17). Do not tighten bolt at this time.
5. Install bolt and nut fastening stabilizer link to knuckle. Do not tighten bolt at this time.
6. Install bolt fastening toe link to knuckle (Fig. 13). Do not tighten bolt at this time.
7. Install bolt and nut fastening compression link to knuckle (Fig. 19). Do not tighten bolt at this time.
NOTE: Prior to using Special Tool 9050A, lubricate Bolt threads to provide ease of use and promote tool longevity.