Pacifica V6-3.8L VIN L (2005)
Stabilizer Bar: Service and Repair
Front Suspension
STABILIZER BAR
REMOVAL
1. Raise and support vehicle.
2. Remove both front wheel and tire assemblies.
3. Remove nut attaching outer tie rod to steering knuckle by holding rod end stud stationary while loosening and removing nut with a wrench.
4. Remove tie rod end from steering knuckle using Remover, Special Tool C-3894-A (Fig. 18).
CAUTION: When removing nut from stud of stabilizer bar link, do not allow stud to rotate in it's socket. Hold stud from rotating by placing an
open-end wrench on flat machined into stud (Fig. 19).
5. Remove stabilizer bar links from each end of stabilizer bar (Fig. 19). To do so, place an open-end wrench on flat machined into link's mounting
stud, then remove nut while holding wrench in place. Push each stud out of hole in stabilizer bar.