Pacifica V6-3.8L VIN L (2005)
10. Completely loosen, but do not remove four bolts fastening hub and bearing in place (Fig. 4). Once loosened from threads in hub and bearing, push
bolts up against rear of hub and bearing to keep brake support plate in place when hub and bearing is removed.
11. Pull hub and bearing off knuckle and half shaft (if equipped with AWD), then thread wheel speed sensor cable through hole in brake support plate
as it is removed with hub and bearing (Fig. 5).
INSTALLATION
1. Position hub and bearing bolts though rear of knuckle and parking brake support just enough to hold support in place as hub and bearing is
installed.
2. Install hub and bearing by first feeding end of wheel speed sensor cable through hole in bottom of parking brake support (Fig. 5). As this is being
done, if equipped with AWD, slide hub and bearing onto half shaft. Place hub and bearing through brake support, onto knuckle, lining up
mounting bolt holes with bolts and placing wheel speed sensor head at bottom.
3. Install four bolts fastening hub and bearing in place (Fig. 4). Tighten mounting bolts to 81 Nm (60 ft. lbs.) torque.
4. Place wheel speed sensor cable routing grommet into bracket on parking brake support (Fig. 3).
5. Route wheel speed sensor cable along toe link and rear suspension crossmember connecting routing clips where shown (Fig. 3).
6. Clip wheel speed sensor connector to spare tire mounting support (Fig. 3).
7. Connect vehicle wiring harness to wheel speed sensor connector (Fig. 3).
8. Install brake rotor and caliper.
9. If equipped with AWD: