PT Cruiser L4-2.4L (2008)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor - Installation
INSTALLATION
CAUTION: Failure to install speed sensor cables properly may result in contact with moving parts or an over extension of cables causing an
open circuit. Be sure that cables are installed, routed, and clipped properly.
1. Place the routing bracket of the wheel speed sensor (1) against the mounting flange (rearward ear) on the rear of the strut (6). Install and tighten
the mounting screw (5) to 12 Nm (105 in. lbs.).
2. Place the heat shield (2) on the wheel speed sensor (1) head.
3. Install the wheel speed sensor (1) head with heat shield (2) on the knuckle (4). Install and tighten the mounting screw (5) to 12 Nm (105 in. lbs.).
4. From the sensor bracket on the strut, loop the harness end of the sensor cable (3) upward, then downward at the outside of the frame rail (6). Install
the speed sensor cable grommet into the retainer on the brake hose bracket (2) on the frame rail.
