PT Cruiser L4-2.4L (2008)
5. Right side sensor - Route the wheel speed sensor cable around the bottom of the frame rail and connect it to the wiring harness connector (1) on
the inside of the frame rail. Remember to push in the locking tab on the connector.
6. Left side sensor - Route the wheel speed sensor cable (5) around the bottom of the frame rail and connect it to the wiring harness connector on the
inside of the frame rail (3). Remember to push in the locking tab on the connector. Attach the speed sensor cable routing clips (4) to the brake tube
(2) on the inside of and under the frame rail.
7. Lower the vehicle.
8. Perform the Diagnostic Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests