PT Cruiser L4-2.4L (2008)
3. Feed the seat belt webbing through the top of the rear seat upper bolster.
4. Install the four bolts to the rear seat upper bolster.
5. Install the Lower Quarter Trim Panel.
6. Install the lower seat belt anchor nut (1). Torque bolt to 40 Nm (30 ft. lbs.).
Front Seat Belt Retractor - Removal
REMOVAL
WARNING: Front seat belt assemblies must be replaced after a collision.
WARNING: If equipped with Seat Belt Tensioners, the retractor will have pyrotechnics inside the retractor assembly and must be handled
with care See: Service Precautions.
1. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this
may result in serious or fatal injury.
2. Slide seat to the full forward position.
3. Using a trim stick or equivalent, gently pry off the seat belt anchor bolt cover (1) on the outboard side of the seat cushion side panel.
4. Remove the seat belt anchor bolt (2).
5. Remove plastic turning loop cover.
6. Remove shoulder belt height control knob.
