PT Cruiser L4-2.4L (2008)
NOTE: The coil springs require proper orientation to the body when installed.
8. Rotate the coil springs (along with the rubber isolators) until the flat end of each upper spring coil lines up with an imaginary line (1) running
parallel with the axle beam as shown. Also, make sure that each upper coil ends near the outboard sides of the vehicle (as shown) and not 180
degrees of that location.
9. Raise the transmission jack guiding the coil springs (2) into the spring mounting brackets (4) on the body of the vehicle. Raise the jack until the
shock absorber lower mounting bolts can be installed though the axle brackets and shock absorber lower mounting eyes.
