PT Cruiser L4-2.4L (2008)
10. Continue to raise the jack until the shock absorber (2) lower mounting bolts (5) can be inserted though the axle brackets and shock absorber lower
mounting eyes.
11. Install the washer (6) and nut (7) on the end of each shock absorber lower mounting bolt. Tighten the mounting bolts to 88 Nm (65 ft. lbs.).
12. Remove the jack.
13. If equipped with a rear stabilizer bar, hook the lower ends of both stabilizer bar cushion retainers (1) into the slots in the rear of the axle (2), then
rotate the opposite end of the retainers upward so the mounting bolts (3) can be installed. Install the mounting bolts and tighten each to 61 Nm (45
ft. lbs.).
CAUTION: When installing the watts links and bell crank to the axle, make sure the bell crank is right-side-up. When mounted properly, the
words "BACK UP" (1) should be able to be read from the rear over the top of the axle.
