PT Cruiser L4-2.4L (2008)
14. Install the bolt (7) from the front securing the watts link bell crank (9) to the center of the axle (11). Place the washer (2) and nut (1) on the end of
the mounting bolt and tighten it to 149 Nm (110 ft. lbs.).
NOTE: Perform STEP 15 through STEP 32 on each side of the vehicle.
15. Position the spindle (6), seal (5) and disc brake adapter (3) on the end of the axle.
16. Clean the threads of the bolts used to mount the disc brake adapter and spindle to the axle, then apply Mopar(R) Stud & Bearing Mount Adhesive
or equivalent to the bolt threads or replace with new mounting bolts.
17. Install the four bolts (7) securing the disc brake adapter and spindle to the axle. Tighten the mounting bolts to 95 Nm (70 ft. lbs.).
