2009 PT Cruiser L4-24L Turbo: Parking Brake Lever Removal Instructions
Parking Brake Lever: Service and Repair
Installation
INSTALLATION
WARNING: The automatic adjusting feature of this parking brake lever contains a clockspring loaded to approximately 19 pounds. Do not
release the automatic adjuster lockout device unless the rear parking brake cables and equalizer are connected to the lever output
cable. Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could
lead to serious injury.
1. Place the parking brake lever (1) on the mounting studs affixed to the vehicle floor pan. Install and tighten the screw and the nut to 28 Nm (250 in.
lbs.).
2. Connect the wiring harness connector to the parking brake warning switch.
3. Install the rear parking brake cables (3) into the equalizer (2) on the parking brake lever output cable (1).
4. Ensure that the parking brake cables are correctly installed on the equalizer and aligned with the cable track on the parking brake lever.