Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
3. Install the motor pack to the hydraulic modulator.
4. Install the Torx head screws securing the motor pack.
Tighten
Tighten the motor pack Torx head screws to 4.5 Nm (40 inch lbs.).
5. Install the gear cover to the hydraulic modulator/motor pack assembly. See: Gear Cover
6. Install the hydraulic modulator/motor pack assembly into the vehicle. See: Hydraulic Modulator/Motor Pack Assembly
Gear Replacement
Disassembly Procedure
1. Remove the motor pack from the hydraulic modulator/motor pack assembly. See: Motor Pack
NOTICE: Do not allow the gear to turn while removing the retaining nut, since the modulator piston can hit the top of the modulator bore,
damaging the piston. Turn the modulator gear to position the piston in the center of its travel. Place a screwdriver through the holes in the gears
(not between the gears) into the recessed hole in the modulator base. This will prevent the gear from turning, aiding in gear removal.
2. Remove the retaining nut holding the gear(s) you are replacing.
3. Remove the gear(s).
Assembly Procedure
