Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
NOTICE:
-
Do not allow the gear to turn while installing the retaining nut. Turn the modulator gear to position the piston in the center of its travel. Place a
screwdriver through the holes in the gears (not between the gears) into the recessed hole in the modulator base. This will prevent the gear from
turning, aiding in gear removal.
-
Install the gears in the same locations they had before removal.
IMPORTANT: Do not lubricate or oil the gears on the motor pack.
1. Install the gear(s) onto the hydraulic modulator. Secure each gear with one nut.
Tighten
Tighten gear nuts to 8.5 Nm (75 inch lbs.).
2. Install the motor pack to the hydraulic modulator. See: Motor Pack
Hydraulic Modulator
Disassembly Procedure
1. Remove the hydraulic modulator/motor pack assembly from the vehicle. See: Hydraulic Modulator/Motor Pack Assembly
2. Remove the two solenoids from the hydraulic modulator/motor pack assembly. See: ABS Solenoid
3. Remove the gear cover from the hydraulic modulator/ motor pack assembly. See: Gear Cover
4. Remove the motor pack from the hydraulic modulator. See: Motor Pack
IMPORTANT: No repair of the hydraulic modulator is authorized, Replace the modulator as an assembly.
Assembly Procedure
