Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
4. Remove the shaft retaining ring using the snap ring pliers J-8059.
5. Remove the axle shaft from the joint assembly.
Caution: The ball retainer is staked in position and must not be disassembled. Cross groove joint internal parts are match fit and cannot be
serviced separately. Improper reassembly will adversely affect both performance and safety.
6. Remove the seal from the joint assembly.
Installation Procedure
1. Install a new small retaining clamp onto the seal. Do not crimp.
2. Install the seal onto the axle shaft.
3. Install the joint assembly onto the axle shaft.
