Caravan AWD V6-201 3.3L (1991)
5.
Firmly pull the buckle cover up (towards the release button) to seat the cover on the buckle (Figure 2).
6.
Install one of the supplied buckle cover retention clips on the buckle strap. Secure the clip by bending the retaining tabs around the narrow section
of the steel strap (Figure 3).
IMPORTANT:
Do not pinch the seat belt switch wire on the driver's seat belt assembly.
7.
Reinstall the strap cover by sliding it up to its original position.
8.
Rotate the buckle assembly to the upright position.
9.
Install the tether and retainer (Figure 1).
NOTE:
The elastic band must be pushed through the steel strap opening before the plastic retainer can be snapped into position.
10.
Repeat Steps 1-9 on the other front seat belt buckle assembly.
11.
For vehicles equipped with Quad Seats: Repeat Steps 1-9 on each rear Quad (bucket) seat belt buckle assembly using two additional clips, PN
CCRR7422.
B. Replace Middle Seat Right Outboard Seat Belt Anchor Clip
1.
Inspect the middle seat, right outboard seat belt anchor clip for the number of rivets retaining the spring clip to the anchor (Figure 4).
