Caravan AWD V6-201 3.3L (1991)
Fig. 13 Torquing inner tie rod pivot
12. Install tie rod assembly on rack. While holding rack in position with a wrench torque inner tie rod pivot housing to 60 ft. lbs.. If rack is not held in
position while tightening tie rod housing, damage to the pinion teeth will result.
13. lubricate inner surfaces of bellows with silicone or other suitable lubricant. Align bellows marks made previously with breather tube and install
bellows with boot seal over housing lip with hole in boot aligned with breather tube. Secure inner clamp.
14. Position bellows outer clamp and jam nut on tie rod. Install tie rod end in the position as removed. Torque jam nut to 55 ft. lbs., then install outer
bellows clamp. Ensure bellows is not twisted.
15. Rearm airbag system, refer to Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair.