Charger V6-3.5L (2009)
18. Install the rocker arm and shaft assembly (2) and ten bolts making sure that the identification marks face toward the front of engine for left head
and toward the rear of the engine for right head.
19. Tighten the ten rocker arm/shaft assembly bolts in the sequence shown to 31 Nm (275 in. lbs.).
20. Clean cylinder head and cover mating surfaces. Inspect and replace gasket (1) and seals (2) as necessary See: Cylinder Head Assembly/Valve
Cover/Service and Repair/Cylinder Head Cover(s) - Installation.
21. Install cylinder head cover and eight bolts. Tighten bolts to 12 Nm (105 in. lbs.).