Dakota Quad Cab 2WD V8-5.9L VIN Z LDC (2002)
2. Lower engine with lifting fixture while guiding insulator assembly into the engine insulator bracket (Fig. 48).
3. Install insulator to bracket thru-bolt. Tighten the thru-bolt nut to 68 Nm (50 ft. lbs.) torque.
4. Remove lifting fixture.
5. Connect the negative cable to the battery.
4WD
1. If engine support brackets were removed, install them and their fasteners (Fig. 49) (Fig. 50). Tighten support bracket to block bolts to 41 Nm (30
ft. lbs.). Tighten support bracket to transmission bellhousing bolt(s) to 88 Nm (65 ft. lbs.).
2. Install Engine mount insulator and tighten insulator to support bracket nut to 41 Nm (30 ft. lbs.). Tighten insulator to support bracket through bolt
nut to 102 Nm (75 ft. lbs.).
3. Lower engine and install insulator to frame through bolt and nut (Fig. 51). Tighten nut to 95 Nm (70 ft. lbs.).
4. Install starter motor.
5. Connect starter wires.
6. Remove engine lifting (support) fixture.
7. Install front axle assembly.
8. Lower the vehicle.
9. Connect the negative cable to the battery.