Durango 4WD V8-5.9L VIN Z (1998)
Canister Purge Solenoid: Service and Repair
Duty Cycle EVAP Purge Solenoid
NOTE: The duty cycle EVAP canister purge solenoid is located at the rear of the intake manifold (Fig. 16).
REMOVAL
1. Remove air cleaner housing.
2. Disconnect electrical wiring connector at solenoid (Fig. 16).
3. Disconnect vacuum harness at solenoid (Fig. 16).
4. Remove support bracket mounting bolt at intake manifold.
5. Remove solenoid and its support bracket from intake manifold.
INSTALLATION
1. Install EVAP canister purge solenoid and its mounting bracket to intake manifold. Tighten mounting bolt to 11 Nm (95 in lb) torque.
2. Connect vacuum harness and wiring connector.
3. Install air cleaner housing.