Durango 4WD V8-5.9L VIN Z (1998)
Leak Detection Pump Mounting
10. Remove 3 LDP mounting screws and remove LDP from vehicle.
INSTALLATION
1. Install LDP to bottom of battery tray. Tighten screws to 1 Nm (11 in. lbs.) torque.
2. Carefully install vapor/vacuum lines to LDP. The vapor/vacuum lines and hoses must be firmly connected. Check the vapor/vacuum lines at the
LDP, LDP filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set
3. Connect electrical connector to LDP.
4. Install battery tray.
5. Install PDC to fender and battery tray (snaps on to battery tray).
6. Install LDP filter to battery tray (one clip).
7. Install connecting hose to bottom of LDP filter.
8. Connect battery temperature sensor pigtail wiring harness.
9. Install battery.
10. Connect negative battery cable to battery.