Durango 4WD V8-5.9L VIN Z (1998)
Fig 37 Fuel Injector Mounting - Typical
Fig. 30 Injector Retaining Clips - Typical Injector
12. Remove the clip(s) retaining the injector(s) to fuel rail.
INSTALLATION
1. Apply a small amount of engine oil to each fuel injector 0-ring. This will help in fuel rail installation.
2. Install injector(s) and injector clip(s) to fuel rail.
3. Position the fuel rail/fuel injector assembly to the injector openings on the intake manifold.
4. Guide each injector into the intake manifold. Be careful not to tear the injector 0-ring.
5. Push the right fuel rail down until fuel injectors have bottomed on injector shoulder. Push the left fuel rail down until fuel injectors have bottomed
on injector shoulder.
6. Install fuel rail mounting bolts.
7. Install EVAP canister purge solenoid to intake manifold.
8. Connect electrical connector to intake manifold air temperature sensor.
9. Connect wiring to all fuel injectors. The injector wiring harness is numerically tagged.
10. Install the A/C support bracket (if equipped).
11. Install throttle body to intake manifold.
12. Install fuel tube (line) at side of fuel rail.
13. Install air cleaner.
14. Connect battery cable to battery.
15. Start engine and check for leaks.
