Durango 4WD V8-5.9L VIN Z (1998)
1.
Connect the MDS1 (Mopar Diagnostic System) and DRB III(R) (Scan Tool) to the vehicle and power them up.
2.
Use the arrow keys and select # 2 CONNECT TO MDS1 OR MDS2 on the DRB III(R) MAIN MENU SCREEN.
3.
Use the arrow keys and select MDS DIAGNOSTICS OR DRB III(R) UPDATE on the DRB III(R) MAIN MENU SCREEN.
4.
Use the arrow keys and select DIAGNOSTIC MENU on the MDS1, then press NEXT MENU.
5.
Use the arrow keys and select VEHICLE CONTROLLER PROGRAMMING on the MDS1, then press NEXT MENU.
6.
Use the arrow keys and select PROGRAMMING OF ALL OTHER CONTROLLERS USING THE MDS1 & DRB III(R) on the MDS, then press
NEXT MENU.
7.
Follow the steps presented on the MDS1 and DRB III(R) that will allow the DRB III(R) to obtain the current part number of the PCM.
8.
The MDS1 will display the vehicle's PCM part number and the replacement part number(s). Press NEXT MENU to begin programming.
NOTE:
A NO UPDATES AVAILABLE MESSAGE MAY BE DISPLAYED. CHECK THE PCM PART NUMBER ON THE VEHICLE AND COMPARE
IT TO THE PART NUMBER DISPLAYED ON THE MDS. IF NO UPDATES ARE AVAILABLE, FIRST CHECK YOUR DIAGNOSTIC
EQUIPMENT FOR THE LATEST SOFTWARE LEVELS AS LISTED EARLIER IN THIS BULLETIN. IF THE LATEST SOFTWARE IS
INSTALLED, ANOTHER VEHICLE CONDITION EXISTS THAT WILL REQUIRE FURTHER INVESTIGATION.
9.
The MDS1 and DRB III(R) will prompt for any operator action needed during the remainder of the reprogramming process.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
10.
Type the necessary information on the "Authorized Software Update Label" p/n 04669020 (Figure 1). Attach the label to the PCM and cover the
label with the clear plastic overlay.
11.
Type the necessary information on the "Authorized Modification Label" p/n 04275086 and attach the label near the VECI label (Figure 2).
MDS2 Procedure
1.
Log onto the MDS2 system.
2.
Connect the MDS2 (Mopar Diagnostic System) and DRB III(R) (Scan Tool) to the vehicle and switch the ignition key to "ON".
3.
Use the arrow keys and select # 2 CONNECT TO MDS1 OR MDS2 on the DRB III(R) MAIN MENU SCREEN.
4.
Use the arrow keys and select # 2 RUN MDS2 APPLICATION on the DRB III(R) MAIN MENU SCREEN.
