dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Front Brake Caliper - Rattle Noise on Rough Roads|Page 5472 > < Lower Control Arm|Page 5463
Page 1
background image

Technical Service Bulletin # 05-06-98

Date: 981009

Front Brake Caliper - Rattle Noise on Rough Roads

NO: 05-06-98

GROUP: Brakes

DATE: Oct. 9, 1998

SUBJECT:
Rattle Noise Coming From Front Brake Caliper Area

MODELS:

1998 (DN) Durango

SYMPTOM/CONDITION:

Rattle noise coming from the front brake caliper area while driving on a rough surfaced road that disappears when the brakes are applied.

DIAGNOSIS:

While driving the vehicle on a rough surfaced road, listen for a rattling noise coming from the front brake caliper area. If a rattling noise is heard, lightly
apply the brakes. If the noise disappears, perform the following Repair Procedure.

PARTS REQUIRED:

1

05014095AB

Kit, Front Brake Shoe

AR (1)

52O3945OAB

Knuckle, Right Side Steering

AR (1)

52039451AB

Knuckle, Left Side Steering

AR (1)

04318080

Fluid, Mopar Brake

POLICY:

Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No:

05-70-22-93

Replace Front Brake Shoes

0.6 Hrs.

Related Operation No:

02-05-31-50

Replace Steering Knuckle, Right Side

0.9 Hrs.

02-05-31-51

Replace Steering Knuckle, Left Side

0.9 Hrs.

FAILURE CODE: P8 - New Part

Repair Procedure

This bulletin involves installing a revised set of front brake shoes.

1.

Clean master cylinder reservoir and filler caps.

2.

Remove the reservoir filler cap and drain approximately 1/4 of the fluid from the reservoir. Use a clean suction gun or similar device to drain the 
brake fluid.

3.

Raise and support the vehicle.

4.

Remove front wheel and tire assemblies.

5.

Bottom the caliper pistons in the caliper bores using a large C-clamp. Position the C-clamp frame on the rear of the caliper and clamp screw on the
outboard brake shoe.

Front Brake Caliper - Rattle Noise on Rough Roads|Page 5472 > < Lower Control Arm|Page 5463