Durango 4WD V8-5.9L VIN Z (1998)
9. Remove the hub/bearing from the steering knuckle.
INSTALLATION
1. Install the hub/bearing to the steering knuckle and tighten the bolts to 166 Nm (123 ft. lbs.).
NOTE: When installing hub/bearing with ABS brakes, position the speed sensor opening towards the front of the vehicle.
2. Install the knuckle onto the upper and lower ball stud.
3. Install the upper and lower ball stud nuts. Tighten the upper ball stud nut to 81 Nm (60 ft. lbs.) and the lower ball stud nut to 183 Nm (135 ft. lbs.)
then install cotter pins.
4. Remove the hydraulic jack from the lower suspension arm.
5. Install the tie rod end and tighten the nut to 88 Nm (65 ft. lbs.). Install the cotter pin.
6. Install the front driveshaft, refer to Transmission and Drivetrain.
7. Install the ABS wheel speed sensor if equipped and brake shield, rotor and caliper. Refer to Brakes and Traction Control.
8. Install the wheel and tire assembly.
9. Remove support and lower the vehicle.
