Journey AWD V6-3.5L (2009)
17. Disconnect the rear heater-A/C wire harness connector (1) from the rear mode door actuator (3) located on the outboard side of the rear
heater-A/C distribution housing (2) and remove the wire harness from the rear heater-A/C housing (5).
18. Remove the three metal retaining clips (4) that secure the rear distribution housing to the rear heater-A/C housing.
19. Release the five plastic retaining tabs (4) that secure the rear distribution housing and rear heater-A/C housing together and separate the housings.
20. If required, remove the rear mode door actuator from the rear distribution housing See: Air Door/Air Door Actuator / Motor/Service and
Repair/Mode Door Actuator - Removal.
21. Remove the screw (1) that secures the rear heater core tubes (3) to the outboard side of the rear heater-A/C housing (4).
22. Pull the rear heater core (5) out of the top of the rear heater-A/C housing. If the foam seals on the heater core are deformed or damaged, they must
be replaced.
Front Air Distribution Housing
HOUSING-AIR DISTRIBUTION
NOTE: LHD model with A/C shown in illustrations. Heater-only models similar.