Magnum SRT-8 V8-6.1L VIN 3 (2006)
Brake Bleeding: Service and Repair
Base Brake System
BASE BRAKE BLEEDING - SRT8
Use the following procedure to bleed the rear brake calipers of this vehicle. The front brake calipers may be bled using the same procedure as the
standard model.
CAUTION: Before removing the master cylinder cover, wipe it clean to prevent dirt and other foreign matter from dropping into the master cylinder.
CAUTION: Use only Mopar brake fluid or an equivalent from a fresh, tightly sealed container. Brake fluid must conform to DOT 3 specifications.
NOTE: Do not pump the brake pedal at any time while having a bleeder screw open during the bleeding process. This will only increase the amount
of air in the system and make additional bleeding necessary.
NOTE: Do not allow the master cylinder reservoir to run out of brake fluid while bleeding the system. An empty reservoir will allow additional air
into the brake system. Check the fluid level frequently and add fluid as needed.
NOTE: Pressure bleeding is highly recommended to bleed this brake system to ensure all air is removed from system. Manual bleeding may also be
used, but additional time is needed to remove all air from system.
Although it is recommended that the base brake system be bled using the pressure method, the manual method can also be performed. Both methods
are presented in this text.
PRESSURE BLEEDING METHOD
NOTE: Follow pressure bleeder manufacturer's instructions for use of pressure bleeding equipment.
1. Remove filler cap from the top of fluid reservoir (2) on master cylinder.
2. Install Adapter (1), Special Tool 6921, in the caps place on the reservoir (2).
3. Attach Bleeder Tank, Special Tool C-3496-B, or equivalent, to Adapter 6921 (1). Pressurize the system following the pressure bleeder
manufacturer's instructions.
