Magnum SRT-8 V8-6.1L VIN 3 (2006)
1. Install replacement wheel stud into flange of hub and bearing from rear (2). Install a stack of washers (3) (approximately 5, depending on
thickness) over stud, then install a standard wheel mounting (lug) nut (1) on stud with flat side of nut against washers.
2. Tighten wheel mounting nut (1), pulling wheel stud into flange of hub and bearing. Once head of stud (2) is fully seated against rear of hub flange,
remove nut and washers from wheel stud.
3. Install parking brake shoe adjuster (1) between upper and lower parking brake shoes. Position end of adjuster with star wheel upward. Once in
place, slide upper shoe downward against adjuster mounting slot, taking up any slack between two pieces.
4. Using appropriate tools, install spring (3) at adjuster.
NOTE: When measuring brake drum diameter, diameter should be measured in center of shoe contact surface area.
5. Using Brake Shoe Gauge, Special Tool C-3919, or equivalent, measure inside diameter of parking brake drum portion of rotor.
