RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
5. Position pressure plate over disc and onto the flywheel (Fig. 4).
6. Align and hold pressure plate in position and install bolts finger tight.
7. Tighten bolts evenly and a few threads at a time in a diagonal pattern.
CAUTION: Bolts must be tightened evenly and to specified torque to avoid warping pressure plate cover.
8. Tighten pressure plate bolts to 50 Nm (37 ft. lbs.).
9. Remove release lever and release bearing from clutch housing. Apply Mopar high temperature bearing grease to bore of release bearing, release
lever contact surfaces and release lever pivot stud (Fig. 5).