RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
10. Apply light coat of Mopar high temperature bearing grease to splines of transmission input shaft and to release bearing slide surface of the
transmission front bearing retainer (Fig. 6).
CAUTION: Do not over lubricate shaft splines. This can result in grease contamination of the disc.
11. Install release lever and bearing in clutch housing. Verify spring clips that retain fork on pivot ball and release bearing on fork are installed
properly (Fig. 7).
NOTE: If release lever is installed correctly, the lever part number will be toward the bottom of the transmission and right side up. There is also a
stamped "1" in the lever, which goes to the pivot ball side of the transmission.
12. Install transmission and transfer case if equipped.
13. Check fluid level in clutch master cylinder.
