RAM 1500 Truck 4WD V8-5.9L VIN Z (2002)
3. Install clutch master cylinder on dash panel and tighten clutch master cylinder nuts to 28 Nm (21 ft. lbs.).
4. Install clutch master cylinder push rod pin.
5. Connect clutch pedal position interlock switch wires.
6. Install plastic clip securing hydraulic line to the dash panel into the lower dash panel flange.
7. Install plastic clip securing hydraulic line to the dash panel onto the upper dash panel stud.
8. Raise vehicle.
9. Install slave cylinder and verify cylinder rod is properly seated in release lever.
10. Install and tighten slave cylinder nuts to 23 Nm (17 ft. lbs.).
11. If new clutch linkage is being installed, connect the clutch hydraulic line to the clutch slave cylinder.
CAUTION: Once the clutch hydraulic line is connected to the slave cylinder, it should never be disconnected.
12. Lower vehicle.
13. Operate linkage several times to verify proper operation.
