RAM 3500 HD Truck 2WD L6-6.7L DSL Turbo VIN A (2007)
1. Position the rear air outlets (1) to the back of the rear air outlet housing (2) and engage the lower set of retaining tabs (3).
2. Gently engage the upper set of retaining tabs (4). Make sure all of the retaining tabs are fully seated.
NOTE: Illustration shown with front seat cushions removed for clarity.
3. Position the rear air outlet housing (2) to the rear of the front center seat support (3).
4. Install the two screws (1) that secure the rear air outlet housing to the center seat support. Tighten the screws to 2.2 Nm (20 in. lbs.).
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the instrument panel from cosmetic damage.
