Stratus Coupe V6-3.0L VIN H (2001)
STEP 6. Check wiper motor connector A-03 for damage.
Q: Is wiper motor connector A-03 in good condition?
YES: Go to Step 7.
NO: Repair or replace it. Refer to Harness Connector Inspection. The windshield wiper should work normally.
STEP 7. Check the harness wire between wiper motor connector A-03 and ground.
Q: Is the harness wire between wiper motor connector A03 and ground in good condition?
YES: There is no action to be taken.
NO: Repair it. The windshield wiper should work normally.
STEP 8. Check the front-ECU power supply circuit [ignition switch (ACC)] at the front-ECU connector A-09X.
1. Disconnect the front-ECU connector A-09X and measure at the relay box side.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 9 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Replace the front-ECU. The windshield wiper should work normally.
NO: Go to Step 9.