Stratus Coupe V6-3.0L VIN H (2001)
2. Remove the seat belt warning light bulb. Then measure the resistance between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance between connector C-102 terminal 26 and connector C-101 terminal 52.
The resistance reading at this time should be much the same as the resistance measured at Step (2).
Q: Are the two resistance values extremely different each other?
YES: Repair or replace the combination meter (printed circuit board). The seat belt warning light should work normally.
NO (much the same): Go to Step 7.
STEP 7. Check the combination meter power supply circuit at the combination meter connector C-1O1.
1. Disconnect the combination meter connector C-101 and measure at the harness side.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 52 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 10.
NO: Go to Step 8.