Stratus Coupe V6-3.0L VIN H (2001)
Connectors
CIRCUIT OPERATION
When the fog light switch is turned on while the front-ECU is illuminating the taillights or headlights (low-beam), the ETACS-ECU sends a 'light on'
signal to the front-ECU, causing the front-ECU to illuminate the fog lights.
TECHNICAL DESCRIPTION (COMMENT)
If the taillights and headlights illuminate normally, the fog light relay, the fog light switch, the front-ECU or the ETACS-ECU may be defective.
NOTE: If only one of the fog lights or the fog light indicator light does not illuminate, the relevant bulb may be burned out or the harness wire between
the defective light and the fog light relay may be defective. In this case, check the relevant circuit by referring to Fog Light.
TROUBLESHOOTING HINTS
-
Malfunction of the fog light relay
-
Malfunction of the fog light switch
-
Malfunction of the front-ECU
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the taillights and headlight operation.
Q: Do the taillights and headlights illuminate normally?
