Stratus Coupe V6-3.0L VIN H (2001)
3. Install the bulb to the combination meter, and then measure the resistance between connector C-102 terminal 30 and 31. The resistance reading at
this time should be muck the same as the resistance measured at Step (2).
Q: Are the two resistance values extremely different each other?
YES: Repair or replace the combination meter (printed-circuit board). The security indicator light should illuminate, and the theft-alarm
system should be armed normally.
NO: Go to Step 5.
STEP 5. Check the combination meter power supply circuit at the combination meter connector C-102.
1. Disconnect the combination meter connector C-102 and measure at the harness side.
2. Measure the voltage between terminal 31 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 8.
NO: Go to Step6.
STEP 6. Check combination meter connector C-102 for damage.
Q: Is combination meter connector C-102 in good condition?
YES: Go to Step 7.
NO: Repair or replace it. Refer to Harness Connector Inspection. The security indicator light should illuminate, and the theft-alarm system should be
armed normally.