Stratus Coupe V6-3.0L VIN H (2001)
STEP 8. Check combination meter connector C-102 and ETACS-ECU connector C-312 for damage.
Q: Are combination meter connector C-102 and ETACS-ECU connector C-312 in good condition?
YES: Go to Step 9.
NO: Repair or replace them. Refer to Harness Connector Inspection. The security indicator light should illuminate, and the theft-alarm system should
be armed normally.
STEP 9. Check the harness wire between combination meter connector C-102 and ETACS-ECU connector C-312.
Q: Is the harness wire between combination meter connector C-102 and ETACS-ECU connector C-312 in good condition?
YES: There is no action to be taken.
NO: Repair it. The security indicator light should illuminate, and the theft-alarm system should be armed normally.
STEP 10. Check the input signal (by using scan tool MB991502).
Check the input signals from the following switches:
-
Ignition key reminder switch
-
Driver's and passenger's door switch
-
Door switches
-
Driver's and passenger's door key cylinder switch
-
Driver's and front passenger's door lock actuator switch
-
Trunk lid latch switch
-
Trunk lid lock key cylinder switch
-
Transmitter
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.