Engine (98 range) (page 2 of 3)
- Make
- Fiat
- Model
- Bravo /Brava (182) Factory Service Manual
- Year
- 1995–2001
- Section
- Engine (98 range)
00 Introduction and technical dataEngine (98 range) · page 2 of 3
DATA FOR CHECKING LUCAS FT09 INJECTION PUMP FOR 1910 TD 100 ENGINE
GENERAL TEST CONDITIONS
- Test oil: ISO 4113 (SHELL S-9365)
- Temperature of test oil: 40° ± 1°C
- Injectors ISO 9008-025A
- Injector setting 130÷133 bar
- Injectors RDNOSDC 6876
- Supply pressure: 0,1 bar
- Direction of rotation: clockwise (seen from control side)
- Injection piping: 2,5×6×330 mm
- Max engine free running speed: 5000±50 rpm
- Engine speed idle 850±20 rpm
- Fitting: 0±1° with cyl. n° 1 at TDC
| Type of check or adjustment | Op. N° | Adjust. lever pos. | Rotation speed rpm | Av. capacity per cyl. mm³/cycle | Advance α° | Max. discr. btwn flow rates mm³/cycle | Ops. or checks to be carried out |
|---|---|---|---|---|---|---|---|
| Filling and bleeding | 1 | Max | 0 | – | – | – | Fill pump with test fluid through filler on cover |
| Electrical supply | 2 | Max | 0 | – | – | – | With supplier stabilized at 11V the control unit is the interface |
| Advance instrument setting | 3 | Max | 0 | – | 0 | – | Adjust acting on the potentiometer on the reader |
| Check hydraulic continuity | 4 | Max | 1000 | – | – | – | Let the pump run for 3 minutes checking that there is no air in the fluid |
| Let oil temp. warm up | 5 | Max | 2000 | – | – | – | Stabilize the temperature at 40÷40,5 °C (pump outlet) |
| Dynamic fitting | 6 | Max | 1500 | – | 6° | – | Supercharging pressure 1 bar Act on the variable pick-up |
| Max no load check | 7 | Max | 2530 | 19±4 | – | 4 | Supercharging pressure 1 bar |
| Regulator intervention check | 8 | Max | 2330 | 405±4 | – | 4 | Supercharging pressure 1 bar |
| Max capacity check | 9 | Max | 2100 | 56,5±2 | 7,5±0,5 | 4 | Supercharging pressure 1 bar |
| Max capacity check | 10 | Max | 1250 | 55,4±2 | 4,5±0,5 | 4 | Supercharging pressure 1 bar |
| Start of supercharging intervention | 11 | Max | 750 | 40,2±2,5 | 1,5±0,5 | 4 | Supply pressure 0,15 bar |
| Supercharging device gradient | 12 | Max | 750 | Q12-Q11 =11±2 | 0 | 4 | Supercharging pressure 0,45 bar |
Parts & tools for this job For 1995 Fiat Bravo
- PARTEngine gasket setSearch: Fiat Bravo 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.