Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)01 · 00 Introduction and technical data
01 · General

Stabilizer bar

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Wheels (98 range) › Stabilizer bar
00 Introduction and technical dataStabilizer bar

Rear suspension independent with ductile cast iron tie rods. Coil springs and dampers with vulcanised bushes. Anti-roll torsion bar. Rigid H-shaped subframe consisting of one transverse tubular element and two moulded rails fastened to it.

VERSIONS BRAVO BRAVO BRAVA
16v JTD 20v 16v JTD
Coil spring
Diameter of wire mm 11.5±0.05
(11.9±0.05)*
11.8±0.05 11.9±0.05
Number of turns 4.75(5)* 4.5 5
Direction of coil clockwise
Height of spring released mm 311 (309)* 297 309
Spring height under
load of:
270 - 298 daN
(286- 316 daN)* mm
194 - -
275 - 303 daN mm - 194 -
286 - 316 daN mm - - 194
The springs are subdivided into two categories, identifiable by a mark:
yellow (1) springs
loaded to:
284 daN (301 daN)* height of mm >194 - -
289 daN height of mm - >194 -
301 daN height of mm - - >194
green (1) springs
loaded to:
284 daN (301 daN)* height of mm ≤194 - -
289 daN height of mm - ≤194 -
301 daN height of mm - - ≤194

(1) Springs of the same category must be fitted together

(*) For 1910 JTD cars with air conditioning.

Shock absorbers
Type: telescopic, double-acting
(low pressure gas type)
WAY-ASSAUTO
Open (damping starts) mm 322.5 ± 2 312 ± 2 322.5 ± 2
Closed (steel against steel) mm 223 ± 2 223 ± 2 223 ± 2
Stroke mm 99.5 89 99.5

Stabilizer bar

Diameter of stabilizer bar mm 17

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.