Exhaust manifold

1. Loosen the band securing the catalyzer by adjusting the bolt (1) and undo the bolts (2) fixing the band to the bracket.
2. Disconnect the connector for the rear Lambda sensor and release the cable from the securing bands along the routing.
3. Raise the vehicle, undo the bolts fixing the catalytic converter to the rear exhaust pipe and detach the converter, complete with rear Lambda sensor.

EXHAUST MANIFOLD

Removing-Refitting

• Position the vehicle on a lift, disconnect the negative battery terminal and detach the following components, as described in the relevant paragraphs:
• Front Lambda sensor
• Catalytic converter heat shield
• Catalytic converter.

4. Remove the protection for the power assisted steering pump drive belt.