Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Dismantling (page 2 of 2)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Drive shafts (1370 12v)
21 Gearbox and differentialDismantling · page 2 of 2
Diagram of a drive shaft assembly showing a dimension of 201 mm from the center of the constant velocity joint to the end of the shaft.
  1. If interventions on the right drive shaft involve dismantling the damping weight, during reassembly refit the weight at the distance specified in the figure.
  2. Undo the clips securing the protective gaiter on the constant velocity joint, wheel side, then withdraw it from the side opposite the drive shaft.
  3. Clean the grease off the inside of the constant velocity joint, and using tools 1847017001 and 1860889000 simultaneously on the circlip inside the joint, remove the joint from the drive shaft.
  4. Check that the drive shaft is not deformed or out of true, and that the seal contact surface is not worn.
Close-up view of a constant velocity joint with a protective gaiter attached to the drive shaft.
Hands using two tools, labeled 1860889000 and 1847017001, to manipulate a circlip inside a constant velocity joint.
A complete metal drive shaft lying diagonally.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.