Kick-down switch

1. Fit the valve assembly cover and tighten the bolts.

The bolts securing the valve assembly cover are of different lengths. Arrange the bolts as shown in the figure and tighten them to a torque of 1.96 - 2.74 daNm.

NOTE Fit the gearbox oil drain plug and tighten to a torque of 2.35-5.49 daNm. Top up the oil level, then check that there are no oil leaks from the valve assembly cover or drain plug.

Finish refitting the valve assembly by reversing the procedure for removal.

KICK-DOWN SWITCH

The kick-down switch is located on the accelerator pedal. To remove this switch, release the lugs which secure the switch to the mounting bracket. Disconnect the supply connector (1), then replace the switch.

It is virtually essential to replace the kick-down switch if it is removed, as the retaining lugs could break during removal.