Auto transmission & differential

Auto transmission & differential

1. Undo the bolts shown in the figure securing the valve assembly, then remove the complete assembly.

Refitting

2. Insert the lever (1) of the selector valve in the hole of the lever (2).
3. Position the valve assembly and tighten the fixing bolts. Connect the solenoid supply connectors and fit the gearbox oil temperature sensor on the mounting bracket.

The valve assembly bolts are of different lengths. Arrange the bolts as shown in the figure.

5. Using solvent, clean off any sealant residues from the valve assembly cover. Apply a bead of silicone sealant 1-1.5 mm thick along the edge of the cover, cleaning off any surplus inside the cover.