Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing-refitting

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (Automatic) › Removing-refitting
21 Gearbox and differentialRemoving-refitting

Removing-refitting

21-27.

Diagram showing the coupling of the converter to the flywheel with a bolt labeled 1.
When coupling the converter to the flywheel, use bolts of the correct length (M8x1.25 bolts with tapered shakeproof washer drawing 46450230, of the dimensions indicated in the figure) and make sure that they are not mixed up with other bolts.
  1. Bolts which are too long could damage the other end of the converter and deform the clutch seal.
  2. Bolts which are too short may not withstand the input torque and could break.
Technical drawing of a bolt with tapered shakeproof washer showing dimensions 1.9, 2 max, and 12.5±0.1.
Diagram showing the automatic transmission with arrows indicating the direction for fitting drive shafts.
When fitting the drive shafts, take particular care not to damage the differential oil seal (2) on the splined part (1) of the drive shaft. Insert the drive shaft perfectly horizontally. If the seal is damaged, it could cause oil leaks.

Make sure that the drive shaft is clean before assembly to avoid foreign bodies entering into the differential.

Cross-section diagram of a drive shaft splined part (1) and differential oil seal (2).

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.